Loading ...
Loading ...
Loading ...
10 49-3000193
ENGLISH
CARE AND CLEANING
Water Tank
REMOVE THE CONDENSED WATER IN THE TANK AFTER EVERY DRYING CYCLE.
NOTE: If drain hose is installed, emptying the water tank is not required. See the
CONNECTING THE DRAIN HOSE section in the Installation Installations of this manual.
• Pull out the water tank.
When removing the water tank from the product, hold it using both hands as it is
heavy and take care not to spill any water inside the tank.
• Remove the condensed water inside the water tank.
To avoid over filling, which could lead to water leaking outside the unit, drain water left
in water tank after each cycle. Over filling will cause cycle to stop prematurely until
emptied.
NOTE: When the Empty Tank indicator light is on, the dryer will not operate until the tank is
emptied and the indicator has been cleared. Press the Start button and the indicator light
will turn off and the dryer will resume the cycle.
Condenser
THE CONDENSER SHOULD BE CLEANED ONCE PER MONTH.
• Open the condenser compartment cover.
• Unlock both locking tabs.
• Remove the condenser box from
the condenser compartment.
• Clean the condenser box and inside the condenser compartment completely. Use tap water
to clean between the grooves of the condenser box by allowing tap water to flow through
it. Reach inside the condenser compartment and wipe away all debris. Make sure the rubber
gaskets on the condenser box are free of debris before reinstalling.
NOTES:
• Make sure to clean your condenser once per month to prevent degradation of the dryer’s
performance.
• When assembling the condenser after cleaning it, make sure the locking tabs are set to the
lock position. Never run the dryer without the condenser installed.
Unlock
Drain hole
is on the
top rear of
the drawer
Loading ...
Loading ...
Loading ...