Loading page 1...
Loading page 2...
Loading page 3...
Loading page 4...
Loading page 5...
Loading page 6...
Loading page 7...
Loading page 8...
Loading page 9...
Loading page 10...
Loading page 11...
Loading page 12...
Loading page 13...
Loading page 14...
Loading page 15...
Loading page 16...
Loading page 17...
Loading page 18...
Loading page 19...
Loading page 20...
Loading page 21...
Loading page 22...
Loading page 23...
Loading page 24...
Loading page 25...
Loading page 26...
Loading page 27...
Loading page 28...
Reset E3 View Monitor
1.
Press the Display Option key at the first setup option screen (Time).
The console will display RESET and Reset Defaults? NO.
To exit without resetting, press the ENTER key.
2.
Press the UP or DOWN keys to select YES.
3.
Press the ENTER key to reset the console to the default values.
The console will beep twice and return to setup mode.
Exit Set Up mode
Press the STOP key to exit Setup options.
Testing Operation
Use the following instructions to test the full resistance and incline range of the unit:
1. Plug the optional power cord into a power outlet from a grounded circuit.
Coil up the remainder of the power cord and place it out of the way. If you do not have the optional
power supply, skip to step 3.
2. Verify the control panel will illuminate and is in Dormant Mode.
3. Hold the handrails to steady self while stepping into the foot plates.
4. Begin striding.
5. Verify lower heart rate cable is not rubbing on handle during operation.
6. Press Quick Start.
7. Run unit through full resistance range.
First press the Resistance + key until unit reaches its highest load (the display will show 100). Then
press the Resistance - key until unit reaches its lowest load (the display will show 0).
When unit reaches the set incline and resistance, the displays will stop flashing and remain steadily
illuminated to indicate the desired settings have been reached.
8. Run unit through full incline range.
First press the Incline key until the unit reaches its highest incline (the display will show 20). Then
press the Incline key until unit reaches its lowest incline (the display will show 0).
Moving parts and fall hazard.
• To avoid serious injury wait until foot plates come to a complete stop
before getting off unit.
• The moving parts cannot be stopped immediately, the unit is not
equipped with a free wheel.
9. Press STOP twice to bring the incline back to its start position, end the workout review, and return
the display to Dormant Mode.
Page 29 of 68
Cybex 525AT Arc Trainer Part Number 5525-4 G
Loading page 30...
Loading page 31...
Loading page 32...
Loading page 33...
Loading page 34...
Loading page 35...
Loading page 36...
Loading page 37...
Loading page 38...
Loading page 39...
Loading page 40...
Loading page 41...
Loading page 42...
Loading page 43...
Loading page 44...
Loading page 45...
Loading page 46...
Loading page 47...
Loading page 48...
Loading page 49...
Loading page 50...
Loading page 51...
Loading page 52...
Loading page 53...
Loading page 54...
Loading page 55...
Loading page 56...
Loading page 57...
Loading page 58...
Loading page 59...
Loading page 60...
Loading page 61...
Loading page 62...
Loading page 63...
Loading page 64...
Loading page 65...
Loading page 66...
Loading page 67...
Loading page 68...