Loading ...
Loading ...
Loading ...
14
FINAL INSTALLATION
6. Remove one of the three light pan screws (T) from the
light pan (N) and loosen the other two screws. Connect
the single-pin connector from the motor assembly (H)
to the single-pin connector from the light kit (G) -- Blue
to Blue and White to White. Place the key holes in the
light kit (G) over the two light pan screws (T) and turn
clockwise. Re-install the previously removed light pan
screw (T) and tighten all screws.
7. Install the bulbs (O) into the sockets of the light kit (G).
Important: Make sure you allow the bulbs (O) and light
kit (G) to cool before you replace the bulbs (O).
8. Lift the glass bowl (M) into the light pan (N) and turn in
a clockwise direction. Once you feel some resistance,
continue to turn until it locks into place. Note: The glass
should turn about 1/4 of a rotation (approximately 4
inches) before it is secure. The glass is secure once
the pin has passed over and clicked into place on the
left side of the locking mechanism. CAUTION: Failure
to properly secure the glass bowl (M), may cause the
glass to fall, which could cause serious injury.
H
N
T
G
O
G
M
6
7
8
Single-pin
Connector
N
Pin
Locking Mechanism
Loading ...
Loading ...
Loading ...