Loading ...
Loading ...
Loading ...
Rinnai 5 ES_FT_OIM
SAFETY
DO NOT MODIFY THIS APPLIANCE.
You MUST read and understand these instructions fully before operating the heater.
Failure to comply with these instructions could result in a fire or explosion, which could cause
serious injury, death or property damage.
Improper installation, adjustments, service or maintenance can cause serious injury, death or
property damage. Such work must be performed by an authorised person.
Improper installation, adjustments, service or maintenance can cause serious injury, death or
property damage. Such work must be performed by an authorised person.
The appliance must be installed in accordance with the local gas and electrical authority
regulations.
Flue terminal must always vent directly to outdoors.
DO NOT extend the flue vertically or horizontally in ways other than prescribed in the appliance
manufacturers’ flue installation instructions.
For information on gas consumption, see data plate on the appliance.
This appliance must not be installed where curtains or other combustible materials could come
into contact with it. In some cases curtains may need restraining.
Not intended for a fireplace insert, DO NOT
build into bookcases or walls etc.
The clearances shown must be maintained.
Heat radiating from the front of this heater may
over time affect the appearance of some
materials used for flooring such as carpet,
vinyl, cork or timber.
This effect may be amplified if the air in the
room contains cooking vapours or cigarette
smoke.
To avoid this possibility, it is recommended
that a mat or similar protective sheet be placed
in front of the appliance, extending for at least
750 mm.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
The appliance is not intended for use by young children or infirm persons without supervision.
Young Children must be supervised when in the vicinity of this heater while it is in operation.
If the supply cord is damaged or requires replacing, it must be replaced by the manufacturer or
the manufacturer's agent or similarly qualified person in order to avoid a hazard.
The heater MUST NOT BE located immediately below a power point.
DO NOT connect to an LPG Gas cylinder indoors.
A dedicated 230V / 240V 50Hz earthed 10 Amp power point must be used with this appliance.
DO NOT modify this appliance. Modifying from original specifications may create a dangerous
situation and will void your warranty.
Only the flue components specified by Rinnai must be used.
Unpack the heater and check for damage. DO NOT INSTALL A DAMAGED HEATER. If the heater
is damaged, contact your supplier for advice.
Before installing the heater, check the label for the correct gas type (refer to the data label at the
rear of the heater). Refer to local gas authority for confirmation of the gas type if you are in
doubt.
WARN I N G
I M PORT A N T
50 mm
50 mm
T O P
LEFT SI DE RI GH T SI DE
AT L E A S T
750mm
1000 mm
250 mm
FRON T
Loading ...
Loading ...
Loading ...