Loading ...
Loading ...
Loading ...
• Only use the controllers supplied with this blanket.
• For additional protection, it is strongly recommend that the use of a residual current device (RCD)
with a tripping current not exceeding 30mA be used on the circuit supplying this product. If you are
unsure if your home has this device, please contact your nearest Electrical Contractor.
• Always treat Electrical Appliances with the upmost care. Do not use this product in any other fashion
or for any other purpose other than stated in these instructions.
2 Connecting the Controller
Turn Off Power and Remove the Plug from the Power Source
• To fit the controller plug, simply hold the socket with one hand and push the
controller plug all the way until the locking tab locates over the lug on top of the
controller plug.
• To remove the controller, lift the locking tab up with your finger and pull the
controller plug directly out. Do Not Pull the controller cable and Do Not try and pull
the controller plug out without lifting the locking tab as you will damage the socket.
• Do Not fold, roll or kink the cable. Allow the cable to hang freely.
• Ensure the cable is not pulled so tight that it bends hard at the blanket connector
end.
NOTE: Ensure that the electric blanket is sized to suit your mattress i.e. queen
sized electric blanket must be used on a queen sized mattress.
Do not use a single bed blanket on a Double, Queen or King size mattress. The
blanket top must not hang over the edges of the mattress.
Page 5 of 16
Rev Draft
Loading ...
Loading ...
Loading ...